![]() It is possible that the display already has the required settings.ī. Check the switches are set as follows: SW1 - off, SW2 - on, SW3 - on. Digipos WD series - open the dip switch cover under the display at the rear. ![]() Don't connect the pole displays until you have checked the following:Ī. The best idea is to select DM110 as all later models are also compatible with that.Ĩ. Give the new device the logical device name "LineDisplay" Right click LineDisplay and select Add New Device. Highlight LineDisplay as below (this applies if installing either the Digipos or Posiflex displays - not the HP LD220 ):ħ. From the Start menu select OPOS -> Setup OPOS.Ħ. Front Counter needs to find a file that is installed and it must be in the default location.ĥ. Double click the file to install the driver. Copy it to the PCs that are going to use pole displays.Ĥ. Download the file V267ER9.exe (or whichever is the latest) to your PC. Select the OPOS ADK and accept the license agrement.ģ. Paste the above into your web browser's address line.Ģ. ![]() Download the Epson OPOS-Adk drivers from here: This may require that you change the factory dip switch settings.ġ. Your customer pole display must be compatible with the Epson DM series.
0 Comments
Leave a Reply. |